British Standard Brass: Difference between revisions

Content deleted Content added

Inline

Latest revision as of 00:50, 24 September 2020

British Standard Brass or British Brass Thread is an imperial unit based screw thread. It adopts the Whitworth thread form with a pitch of 26 threads per inch and a thread angle of 55 degrees for all diameters.^[1] It is often wrongly called British Standard Brass but is not actually covered by a British Standard.

The reason for adopting 26 tpi, is brass tube has a relatively similar wall thickness irrespective of the outside diameter of the tube, therefore as BSW thread depths are determined by the threads per inch, a lower tpi would reduce the strength of the tube or cut right through it. Brass tube threads can be confused with the British Standard Cycle thread, one of which that is most common is also 26 tpi. The difference being the thread angle of the British Standard Cycle is the same as the metric thread angle of 60 degrees.

Nominal sizes are usually in the range 1⁄8 to 2 inches.

References

^ Terminology related to nuts and bolts, retrieved 2009-10-23.

[1] Terminology related to nuts and bolts, retrieved 2009-10-23.

[1]

@@ Line 1: / Line 1: @@
-{{Unreferenced|date=May 2007}}{{Orphan|date=May 2007}}'''British Brass Thread thread''' is an [[imperial unit]] based [[screw thread]]. It adopts the Whitworth thread form with a pitch of 26 threads per inch for all diameters. It is often wrongly called British Standard Brass but is not actually covered by a [[British Standard]].
+'''British Standard Brass''' or British Brass Thread is an [[imperial unit]] based [[screw thread]]. It adopts the [[Whitworth thread]] form with a pitch of 26 [[threads per inch]] and a thread angle of 55 degrees for all diameters.<ref>{{Citation | title = Terminology related to nuts and bolts | url = http://www.boltscience.com/pages/glossary.htm#b | accessdate = 2009-10-23 | postscript =.}}</ref> It is often wrongly called ''British Standard Brass'' but is not actually covered by a [[British Standard]].
+The reason for adopting 26 tpi, is brass tube has a relatively similar wall thickness irrespective of the outside diameter of the tube, therefore as BSW thread depths are determined by the threads per inch, a lower tpi would reduce the strength of the tube or cut right through it. Brass tube threads can be confused with the [[British Standard Cycle]] thread, one of which that is most common is also 26 tpi. The difference being the thread angle of the British Standard Cycle is the same as the metric thread angle of 60 degrees.
-Nominal sizes are usually in the range 1/8 to 2 inches.
+[[Nominal size]]s are usually in the range {{frac|1|8}} to 2&nbsp;inches.
-==See also==
-Other [[Imperial Unit]] thread standards:
+==See also==
+* [[British Standard Pipe]] (BSP)
+* [[British Standard Whitworth]]
+* [[National pipe thread]] (NPT)
 * [[Unified Thread Standard]] (UTS, including UNC, UNF and UNEF)
-* [[British standard pipe thread]] (BSP)
+==References==
-[[Category:Mechanical standards]]
+{{Reflist}}
+[[Category:Thread standards]]
 [[Category:Screws]]
+[[Category:Standards of the United Kingdom]]