Elektor Junior Computer: Difference between revisions
No edit summary |
No edit summary |
||
| Line 4: | Line 4: | ||
It was delivered as a [[Electronic kit]], or you could just buy the two [[Printed circuit board]]'s (main board and [[Seven-segment display]] board) only, and add your own components. |
It was delivered as a [[Electronic kit]], or you could just buy the two [[Printed circuit board]]'s (main board and [[Seven-segment display]] board) only, and add your own components. |
||
As It was much lower in price than an original KIM, many more Junior computers (several thousands) were used in the Netherlands, and |
As It was much lower in price than an original KIM, many more Junior computers (several thousands) were used in the Netherlands, Germany and France, than original KIM-1's. |
||
Later extension boards were developed, and a BASIC interpreter was ported. |
Later extension boards were developed, and a BASIC interpreter was ported. |
||
Revision as of 22:17, 1 April 2008
The Elector Junior Computer was a simple 6502 based Microprocessor development board published in the 1980's in the Dutch, German and later French versions of Elektor/Electuur, in the form of a series of articles, and four books. It was developed by the German engineer Loys Nachtmann. In fact the Junior Computer was a virtual clone of the KIM-1, only it did not use the special I/O+ROM chips (MCS6530) but rather an of the shelf 6522 VIA and a 2716 2K EPROM. It also had a differerent physical shape, as it used the Eurocard board, and a 31 pin-DIN connectors for I/O and a DIN 41612 connector for system expansion. It was delivered as a Electronic kit, or you could just buy the two Printed circuit board's (main board and Seven-segment display board) only, and add your own components.
As It was much lower in price than an original KIM, many more Junior computers (several thousands) were used in the Netherlands, Germany and France, than original KIM-1's.
Later extension boards were developed, and a BASIC interpreter was ported. Elector Expansion boards specifically for the junior were a VDU (video terminal) (the "elekterminal"), an EPROM and SRAM expansion board, an 16/64KB DRAM board and EPROM programmer board, and even a Floppy disk controller, as well as a dozen smaller boards for small improvements and interfaces etc.