IAUDIO: Difference between revisions
| Line 42: | Line 42: | ||
The iAUDIO 5 was introduced in December 2004. It was the successor to the popular iAUDIO 4 series and was powered by the same [[Sigmatel]] chipset that were used in the iAUDIO U2 and G3. The iAUDIO 5 was relatively similar to the aforementioned players. What set it apart from other players was the fact that it had 1000 different backlight colour combinations. It was powered by an AAA battery which allowed for a maximum playback time of up to 20 hours. |
The iAUDIO 5 was introduced in December 2004. It was the successor to the popular iAUDIO 4 series and was powered by the same [[Sigmatel]] chipset that were used in the iAUDIO U2 and G3. The iAUDIO 5 was relatively similar to the aforementioned players. What set it apart from other players was the fact that it had 1000 different backlight colour combinations. It was powered by an AAA battery which allowed for a maximum playback time of up to 20 hours. |
||
===iAUDIO X5=== |
===iAUDIO X5 and X5L=== |
||
[[Image:Iaudio x5.jpg|right|thumb|iAUDIO X5]] |
[[Image:Iaudio x5.jpg|right|thumb|iAUDIO X5]] |
||
The iAUDIO X5 was released in April 2005. |
The iAUDIO X5 was released in April 2005. |
||
Revision as of 14:47, 4 June 2012
 |
iAUDIO is the brand name for a range of portable media players produced by Korean consumer electronics manufacturer Cowon Systems, Inc. iAUDIO products are best known for their high sound quality and wide file format support.[citation needed]
Products
The iAUDIO range consists of players based on both flash memory and hard disk drives. Flash memory-based players are available with a capacity of up to 32 GB, while the hard drive-based models currently have capacities up to 160 GB. The iAUDIO 6 was the first player to use Toshiba's new 4GB 0.85″ hard disk.
iAUDIO CW100 and CW100s
Cowon entered the digital audio player market in October 2000 with the introduction of their first MP3 player, the iAUDIO CW100. In March 2001, the iAUDIO CW100s, a revised model, was released.
iAUDIO CW200 and CW250
In December 2001, Cowon released the iAUDIO CW200. The CW200 had audio playback capabilities, an FM radio and voice recording through a built-in microphone. This player also had a revised model, the iAUDIO CW250.
iAUDIO CW300
In December 2002, Cowon released the iAUDIO CW300. This model was essentially an iAUDIO CW200 using AA batteries as a power supply. Most reviewers also regarded it as having a higher build quality.
iAUDIO 4
The iAUDIO 4 was introduced December 2003. It came with most of the features that users of the CW200 and CW300 had been missing. Upgrades from previous players came in the form of UMS standard, BBE sound processing effects, line in recording and a 124 colour backlight LED display. This player used the STMP 3420 chipset by Sigmatel.
iAUDIO M3
The iAUDIO M3 was introduced March 2004. The player was Cowon's first DAP with an integrated 1.8-inch (46 mm) hard drive. When the M3 was released there was a lot of controversy about it, because the actual unit had no display. All but a few basic functions had to be controlled via the included remote control. Some people liked this concept, others were not so fond of it.
When the iAUDIO M3 was first released outside of Korea, there was a quality issue with the player's remote control. There was a widespread "fading" issue, in which the text of the remote slowly disappeared. This issue was rectified by the rapid recall of all faulty remotes and free replacements.
iAUDIO U2
The iAUDIO U2 was introduced in July 2004. It was also Cowon's first player to feature a navigational joystick instead of the 2 rockers found on most previous releases. The U2 used the STMP 3520 chipset by Sigmatel.
iAUDIO G3 and G2
The iAUDIO G3 was introduced November 2004. The internal hardware was very similar to that of the iAUDIO U2. Both players used the same Sigmatel chipset. The only difference between the two players was that the G3 was powered by an AA battery, allowing a playing time of up to 50 hours.
The iAUDIO G2 was a cheaper version of the G3 which was introduced in the spring of 2005. It lacked some of the main features of the G3: no FM radio, the interface was only USB 1.1 (compared to USB 2.0 on the G3), and the playback time with a single AA battery was down to 40 hours.
iAUDIO 5
The iAUDIO 5 was introduced in December 2004. It was the successor to the popular iAUDIO 4 series and was powered by the same Sigmatel chipset that were used in the iAUDIO U2 and G3. The iAUDIO 5 was relatively similar to the aforementioned players. What set it apart from other players was the fact that it had 1000 different backlight colour combinations. It was powered by an AAA battery which allowed for a maximum playback time of up to 20 hours.
iAUDIO X5 and X5L
The iAUDIO X5 was released in April 2005.
The X5 uses much of the same hardware as the M3, and as such has much of the same features and capabilities. It has almost identical features to the iriver H300 Series. The X5 includes a color screen on the unit.
As with the M3, there is an "L" version which is 4 mm thicker and has a longer battery life. Unlike the M3, the X5 comes in 20, 30, and 60 GB variants. It is likely that there will be no 60 GB X5L, as the 60 GB X5 itself is the thickness of the 20 and 30 GB X5L due to the increased size of the hard drive. The 20, 30, and 60 GB capacities offer a rated battery life of 14 hours for audio playback with a 950 mAh battery. The 20 and 30 GB X5L models specify a rated playback time of 35 hours with a 2250 mAh battery. Video battery life is unspecified. In addition to the "L" versions, the X5 also comes in a "V" variation, which lacks the FM radio.
Cowon announced in May 2007 that the X5 series had been discontinued. Its successor, the X7 series, was slated to be released at some point in the summer of 2007,[1] but was delayed until October 2010.
iAUDIO M5
The iAUDIO M5 is basically a simplified version of the X5. It lacks an FM Radio, a colour screen (it has a greyscale screen instead), and USB-OTG functionality to save production costs. Its casing is a silver color instead of the black X5. There's also an "L" version available, which features enhanced battery life. The "L" version of the player is a little thicker and heavier though and costs slightly more.
iAUDIO F1
Introduced in July 2005, the iAUDIO F1 can be described as an iAUDIO U2 with an interesting design, a colour OLED display, and higher power output (32 mW vs. 20 mW for the U2).
This player was and still is a favorite subject of ridicule among iAUDIO fans.[citation needed] The player's design was supposed to represent that of a Formula 1 sports car, which some criticize for making the F1 look more like a toy than a serious piece of portable audio equipment.
The F1 played Vorbis, WMA, WAV, ASF and MP3 files and could tune to the radio, as well as record from the radio. It could also record directly from sources or record using a built in microphone.
It came in 256 MB/512 MB/1 GB sizes of Flash memory.
iAUDIO U3
Introduced in October 2005, the iAUDIO U3 was the successor to the iAUDIO U2. The main difference between the two players was that the U3 featured a color screen (260,000 colors, 160×128 resolution) which allowed playback of MPEG4 videos encoded in XviD, as well as picture display. Like the iAUDIO X5, the U3 only played video files at up to 15 frame/s with a resolution of 160x128. Most videos must therefore be converted to be played back on the U3 using the provided software from Cowon. The player can also display JPEG and TXT files. The support for audio files was also enhanced from previous models: the U3 was the world's first Flash-based player that was able to play FLAC files (but only from compression rate 0 to 2 with the initial Firmware v1.11. It now supports up to Q8 with V1.13). Another new feature was the U3's powerful sound output of 30 mW per channel (at 16 ohm, achieved by utilizing the new Telechip TCC770 audio chipset and Cirrus Logic CS42L51 Codec). Like the U2 the U3 had a built-in lithium polymer cell for a playback time of up to 20 hours. As with all iAUDIO devices, there was no need for the use of software, since the U3 was a UMS device (though additional software was required to take advantage of some features, such as converting video to the right format to be played back on the player).
With the firmware version 1.20 Cowon added ID3 browsing and DRM capabilities to the U3. This made the U3 the first iAUDIO player that allowed the user to browse its contents by the contents of ID3 tags embedded in the files.
Features:
- 512 MB/1 GB/2 GB/4 GB of flash memory
- 260,000 color TFT LCD screen, with a resolution of 160×128
- Support for MP3, WMA, ASF, WAV, Vorbis, FLAC, and MPEG4 (video)files
- Support for recording in WMA format at 32, 64, 80, 96, and 128 kbit/s
- USB 2.0
- FM radio
- Line in recording
- Voice recording via built-in microphone or an external microphone
- FM radio recording
iAUDIO 6
The iAUDIO was presented in January 2006 at the CES in Las Vegas. It was the first digital audio player to feature a 0.85-inch (22 mm) hard drive. This technology allowed the production of a high capacity digital audio player in a very small form factor.
iAUDIO T2
In August 2006, Cowon released the iAUDIO T2. The T2 was a necklace type audio player. It featured a color screen, though it did not support video or photo viewing. Features included FM radio, voice recording and Cowon's traditional wide codec support: the T2 supported MP3, WMA, Ogg, and WAV audio files.
FLAC was supported up to firmware 1.20, but not by later versions. Firmware 1.20 is no longer available for download from Cowon.
iAUDIO F2
In September 2006, Cowon released the iAUDIO F2. The F2, with a design similar to a mobile phone, was the successor to the F1, and very similar to the U3 in features. Instead of the F1's OLED display, it featured a color LCD display. Apart from FM radio, voice recording and line-in recording, it also featured video playback as well as photo and text viewing.
iAUDIO 7
In June 2007, Cowon announced the iAUDIO 7, a player based on the iAUDIO 6 but with 4, 8, or 16 gigabytes of flash memory instead of a hard drive. The OLED screen from the iAUDIO 6 model was replaced by a TFT with 260,000 colors (18 bit colour depth). The device used a swing-control. Audio recordings could only be saved in WMA format, with a user selectable bitrate of 64, 80, 96, or 128 kbit/s. The device played MP3, WMA, FLAC, Ogg Vorbis, WAV, and ASF audio files as well as Xvid videos. The frame rate of video playback was limited to 15 frames per second. It was produced in Korea.
Unlike its predecessor, the iAUDIO 6, the iAUDIO 7 had no USB host (USB On-the-Go) capabilities.
iAUDIO U5
In August 2007, Cowon announced the iAUDIO U5 at IFA 2007. The U5 featured Windows DRM10 support as well as MP3 and WAV (Ogg and FLAC supported with updated US firmware v3.16).[2] There was no support for video. The U5 came in 4 and 8 GB versions with a 1.8-inch (46 mm) LCD with 128×160 resolution and 65 000 colors. The U5 had a 24-hour continuous audio playback time.
iAUDIO 9
The iAUDIO 9 was released in November 2009, more than two years after its predecessor the i7. It features a new vertical form factor and uses the Wolfson WM8960 audio codec, which allows for a built-in speaker.[3]
iAUDIO E2
The iAUDIO E2 was released in November 2009.
iAUDIO 10
The iAUDIO 10 was released in South Korea in September 2011, with a design similar to the iAUDIO 9.
With a screen resolution of 240×400 pixels, the i10 has the highest resolution of any iAUDIO player.
Upon release, the iAUDIO 10 was awarded Japan's Good Design Award.
Sound enhancements
All Cowon media players, starting with the iAUDIO 4, feature a set of sound enhancement technologies collectively referred to as JetEffect, including a technology known as BBE+, licensed from BBE Sound, Inc. The distinction between JetEffect and BBE+ is not always clear.
On Cowon media players, the JetEffect menu offers the following options:
- A five-band semi-parametric equalizer
- A “BBE+” menu with adjustable settings for “BBE+” (presumably a modified implementation of what BBE calls “process” in its Sonic Maximizers), “Mach3Bass”, “3D Surround” and “MP Enhance” (the latter is described in detail here)
- A “Special Effects” menu with options for stereo enhancement and reverb algorithms
The latest version of JetEffect, JetEffect 5, was introduced with the January 19, 2012 release of the Cowon Z2 Plenue. It included an updated reverb algorithm, allowing the user to choose between nine different types of reverb timbres, including Chamber, Room, Club, Hall, Auditorium, Cathedral, Stadium, Canyon and Long.
All Cowon players following the D2+ (S9 and onwards) come with an updated version of BBE called BBE+.[4]