Fleet Management System: Difference between revisions
GoingBatty (talk | contribs) m Typo fixing, typos fixed: life time → lifetime using AWB (8062) |
Calliewalls (talk | contribs) |
||
| Line 35: | Line 35: | ||
== See also == |
== See also == |
||
* SAE [[J1939]] |
* SAE [[J1939]] |
||
Fleet Management Solutions is the leading systems software provider of Fleet Management Services and Training Solutions to organizations and companies operating in developing and post-conflict countries. We offer fast,reliable,accessible and user-friendly systems that will help your business to perform better and gain profit. <ref>[http://www.fleet-management-solutions.net/ Fleet Management Solutions Helps you to provide your Fleet and in your business.]</ref> |
|||
== External links == |
== External links == |
||
Revision as of 03:26, 5 June 2012
The Fleet Management Systems Interface (FMS) is a standard interface to vehicle data of commercial vehicles. The six European manufacturers Daimler AG, MAN AG, Scania, Volvo (incl. Renault), DAF Trucks and IVECO have developed the so called FMS-Standard in 2002 to make manufacturer independent applications for telematics possible.
The following data are broadcast at the FMS interface:
- Vehicle speed (wheel based)
- Vehicle speed (from tachograph)
- Clutch switch (on/off)
- Brake switch (on/off)
- Cruise control (on/off)
- PTO (Status/Mode)
- Accelerator pedal position (0–100 %)
- Total fuel used (litre since lifetime)
- Fuel level (0–100 %)
- Engine speed
- Axle weight (kg)
- Total engine hours (h)
- FMS-Standard Software Version (supported modes)
- Vehicle identification number (ASCII)
- Tachograph information
- High resolution vehicle distance
- Service distance
- Engine coolant temperature
The data are coded according SAE J1939. The repetition rate of the data is between 20ms (e.g. engine speed) and 10 sec. (e.g. vehicle identification number)
With the FMS-Standard it is now possible to have manufacturer independent applications and evaluations of the data.
The amount of data is dependent on the manufacturer and model of the vehicle and might be different. If some data are not available at the interface they are marked as not available.
According a note from the truck manufacturers the FMS-Standard is seen as a world wide standard. A direct connection to the internal vehicle bus system is not permitted by the truck manufacturers and could lead to the loss of warranty. Meanwhile some manufacturers are quite restrictive in their workshops and cut all unknown connections to the internal bus system
According ACEA ca. 160.000 vehicles were fitted with a FMS-Standard Interface in the year 2007. The FMS-Standard was as well the base for the Bus-FMS-Standard for buses and coaches which was published in the year 2004.
See also
- SAE J1939
Fleet Management Solutions is the leading systems software provider of Fleet Management Services and Training Solutions to organizations and companies operating in developing and post-conflict countries. We offer fast,reliable,accessible and user-friendly systems that will help your business to perform better and gain profit. [1]
External links
| General | |
|---|---|
| Standards |
|
| Storage |
|
| Peripheral | |
| Audio | |
| Portable | |
| Embedded | |
Interfaces are listed by their speed in the (roughly) ascending order, so the interface at the end of each section should be the fastest.  Category | |
 | This product article is a stub. You can help Wikipedia by expanding it. |