Jump to content

Nelson Aircraft: Difference between revisions

From Wikipedia, the free encyclopedia
Content deleted Content added
fixing refs, some copy edit
trying to integrate two conflicting versions, cut out excessive deatils, this would belong in the aircraft type article, not the company article
Line 21: Line 21:


Bowlus and Nelson formed the Nelson Aircraft Corporation to build a two-seat, [[motor glider]] version of the popular [[Bowlus BA-100 Baby Albatross]]. The designers nicknamed this design the ''Bumblebee'' but they sold the powered glider under the official moniker, ''Dragonfly''.<ref name=nasm>[http://www.nasm.si.edu/collections/artifact.cfm?id=A19731120000 NASM ''Nelson BB-1 Dragonfly'' (Long Description)]</ref>
Bowlus and Nelson formed the Nelson Aircraft Corporation to build a two-seat, [[motor glider]] version of the popular [[Bowlus BA-100 Baby Albatross]]. The designers nicknamed this design the ''Bumblebee'' but they sold the powered glider under the official moniker, ''Dragonfly''.<ref name=nasm>[http://www.nasm.si.edu/collections/artifact.cfm?id=A19731120000 NASM ''Nelson BB-1 Dragonfly'' (Long Description)]</ref>

The first Nelson-Bowlus glider was the Nelson ''Bumblebee'' with a pod-and-boom fuselage two-seat powered sailplane [NX1955]. The Bumblebee in 1945-46 was built with a [[Righter O-45]] 16-hp 4-cylinder engine. Nelson Aircraft then developed their own 25-28&nbsp;hp 4-cylinder, two-stroke [[Nelson H-44|H-44]] and [[Nelson H-44|H-49]] engines. These engines were used for a limited production version of the BB-1 Bumblebee called the [[BB-1 Dragonfly]].<ref name="Nelson"/>


==Designs==
==Designs==
The first Nelson-Bowlus glider was the [[Nelson Bumblebee]] with a pod-and-boom fuselage two-seat powered sailplane [NX1955]. The Bumblebee in 1945-46 was built with a [[Righter O-45]] 16-hp 4-cylinder engine. The high pitch sound of the engine is what caused Bowlus and Nelson to name it the "Bumblebee." A 3-gallon gas tank fed the pusher type engine allowing it to fly for an hour and a half under full throttle, cruising at 75 mph. Tests were made which determined the engine was under-powered producing about 16 [[horsepower]] at 3500 rpm, not enough for adequate flight, although Bowlus claimed it would climb 300 feet per minute to an altitude suitable for soaring. The men decided to build a suitable engine of their own design from scratch that was used for the later production models. Their new motor generated 25 horsepower, just enough power for takeoff and a slow climb.<ref name=nasm/>


Nelson Aircraft then developed their own 25-28&nbsp;hp 4-cylinder, two-stroke [[Nelson H-44|H-44]] and [[Nelson H-44|H-49]] engines. These engines were used for a limited production version of the BB-1 Bumblebee called the [[BB-1 Dragonfly]].<ref name="Nelson"/>
The experimental [[Nelson Bumblebee]] was a [[strut-braced]], [[high wing]], [[Bowlus Baby Albatross]] glider design which was altered by widening the [[cockpit]] and adding a plexiglass bubble to improve visibility. It had a 47 ft. wing span with a wing area of 168 sq. ft., horizontal tail surfaces were 16 sq. ft. with vertical tail surfaces being 12 ft.. The ''Dragonfly'' version added [[vertical stabilizer]]s mounted on the ends of the [[horizontal stabilizer]]. The over-all length was 23 ft., height 5 ft., and empty weight of 465 pounds, with 350 pounds allowed for two passengers. The motorglider had side-by-side seating with [[Aircraft flight control system|flight controls]] for each occupant. These included a conventional throttle, choke, mixture controls, altimeter, airspeed and sensitive rate of climb indicators. There was also a magneto ignition with impulse starter so that the engine would not kick back at any time, and a ratchet wire starter mounted on the crankshaft, enabling either pilot in the cockpit to start or stop the engine.<ref name="Cal">"California Bumblebee," Talon Quarterly published by the 17th Airborne Assn, Winter 1946.</ref>


The experimental Nelson Bumblebee was a [[strut-braced]], [[high wing]], [[Bowlus Baby Albatross]] glider design which was altered by widening the [[cockpit]] and adding a plexiglass bubble to improve visibility. The [[Nelson Dragonfly]] version added [[vertical stabilizer]]s mounted on the ends of the [[horizontal stabilizer]]. The motorglider had side-by-side seating with [[Aircraft flight control system|flight controls]] for each occupant.<ref name="Cal">"California Bumblebee," Talon Quarterly published by the 17th Airborne Assn, Winter 1946.</ref>
The prototype had a fully retractable tricycle landing gear, operated manually by the pilot. The nose gear was steerable with miniature shimmy dampeners and a lock. The rear wheels had a special cam action so that they could be tucked away in the fuselage at the proper angle. The rear wheels also had independent internally expanding brakes, designed by Bowlus, which facilitated taxiing on the ground.<ref name="Cal"/>


The prototype Bumblebee had a fully retractable tricycle landing gear, operated manually by the pilot. The nose gear was steerable with miniature shimmy dampeners and a lock. The rear wheels had a special cam action so that they could be tucked away in the fuselage at the proper angle. The rear wheels also had independent internally expanding brakes, designed by Bowlus, which facilitated taxiing on the ground.<ref name="Cal"/>
In studying the fuselage design of the Baby Albatross the [[aft]] section of the fuselage pod was an ideal place to install a [[pusher engine]] and propeller. A small engine was needed to fix in this location, so Nelson and Bowlus selected a 44 lb. [[Ryder Engines|Ryder]] [[four-cylinder]], [[two-cycle]] [[power plant]] which used a 42" wooden propeller. The high pitch of the engine is what caused Bowlus and Nelson to name it the ''Bumblebee." A 3-gallon gas tank fed the pusher type engine allowing it to fly for an hour and a half under full throttle, cruising at 75 mph. Tests were made which determined the engine was under-powered producing about 16 [[horsepower]] at 3500 rpm, not enough for adequate flight, although Bowlus claimed it would climb 300 feet per minute to an altitude suitable for soaring. The men decided to build a suitable engine of their own design from scratch that was used for the later production models. Their new motor generated 25 horsepower, just enough power for takeoff and a slow climb.<ref name=nasm/>


==Aircraft==
==Aircraft==

Revision as of 15:51, 21 February 2015

Nelson Aircraft Corporation
IndustryAerospace
Founded1945
HeadquartersSan Fernando, California, United States
Key people
Ted Nelson
William Hawley Bowlus
ProductsMotor gliders
Aero engines

The Nelson Aircraft Corporation was founded in 1945 by sailplane pilot Ted Nelson and sailplane designer William Hawley Bowlus in San Fernando, California.[1]

Bowlus and Nelson formed the Nelson Aircraft Corporation to build a two-seat, motor glider version of the popular Bowlus BA-100 Baby Albatross. The designers nicknamed this design the Bumblebee but they sold the powered glider under the official moniker, Dragonfly.[2]

Designs

The first Nelson-Bowlus glider was the Nelson Bumblebee with a pod-and-boom fuselage two-seat powered sailplane [NX1955]. The Bumblebee in 1945-46 was built with a Righter O-45 16-hp 4-cylinder engine. The high pitch sound of the engine is what caused Bowlus and Nelson to name it the "Bumblebee." A 3-gallon gas tank fed the pusher type engine allowing it to fly for an hour and a half under full throttle, cruising at 75 mph. Tests were made which determined the engine was under-powered producing about 16 horsepower at 3500 rpm, not enough for adequate flight, although Bowlus claimed it would climb 300 feet per minute to an altitude suitable for soaring. The men decided to build a suitable engine of their own design from scratch that was used for the later production models. Their new motor generated 25 horsepower, just enough power for takeoff and a slow climb.[2]

Nelson Aircraft then developed their own 25-28 hp 4-cylinder, two-stroke H-44 and H-49 engines. These engines were used for a limited production version of the BB-1 Bumblebee called the BB-1 Dragonfly.[1]

The experimental Nelson Bumblebee was a strut-braced, high wing, Bowlus Baby Albatross glider design which was altered by widening the cockpit and adding a plexiglass bubble to improve visibility. The Nelson Dragonfly version added vertical stabilizers mounted on the ends of the horizontal stabilizer. The motorglider had side-by-side seating with flight controls for each occupant.[3]

The prototype Bumblebee had a fully retractable tricycle landing gear, operated manually by the pilot. The nose gear was steerable with miniature shimmy dampeners and a lock. The rear wheels had a special cam action so that they could be tucked away in the fuselage at the proper angle. The rear wheels also had independent internally expanding brakes, designed by Bowlus, which facilitated taxiing on the ground.[3]

Aircraft

Summary of aircraft built by Nelson Aircraft
Model name First flight Number built Type
Nelson Bumblebee Template:Avyear 1 Motor glider
Nelson Dragonfly Template:Avyear 7 Motor glider
Nelson Hummingbird Template:Avyear 7 Motor glider

Engines

Summary of engines built by Nelson Aircraft
Model name Introduced Type
Nelson H-44 Template:Avyear 4-cylinder, 2-stroke, 25 hp at 3,900 rpm[4]
Nelson H-49 Template:Avyear 4-cylinder, 2-stroke, 28 hp at 4,000 rpm[4]
Nelson H-59 Template:Avyear 4-cylinder; 2-stroke, 40 hp at 4,000 rpm[5]
Nelson H-63 Template:Avyear 4-cylinder; 2-stroke; 43 hp at 4,000 rpm[6]

References

  1. ^ a b Aeroengine: Nelson Aircraft
  2. ^ a b NASM Nelson BB-1 Dragonfly (Long Description)
  3. ^ a b "California Bumblebee," Talon Quarterly published by the 17th Airborne Assn, Winter 1946.
  4. ^ a b Federal Aviation Administration (April 1947). "Aircraft Type Certificate Data Sheet GTC19" (PDF). Retrieved 10 March 2011.
  5. ^ Popular Rotocraft Association: Igor Bensen
  6. ^ Federal Aviation Administration (February 1996). "Aircraft Type Certificate Data Sheet 4E1" (PDF). Retrieved 13 March 2011.