Jump to content

.56-56 Spencer

From Wikipedia, the free encyclopedia

This is an old revision of this page, as edited by Wingedhussar1503 (talk | contribs) at 22:03, 25 July 2023 (Nomenclature). The present address (URL) is a permanent link to this revision, which may differ significantly from the current revision.

.56-56 Spencer
TypeRifle
Place of originUnited States
Production history
DesignerChristopher Spencer
Specifications
Case typeRimmed, straight
Bullet diameter.550 in (14.0 mm)
Neck diameter.560 in (14.2 mm)
Shoulder diameter.560 in (14.2 mm)
Base diameter.560 in (14.2 mm)
Rim diameter.645 in (16.4 mm)
Case length.875 in (22.2 mm)
Overall length1.545 in (39.2 mm)
Primer typeRimfire
Maximum pressure (CIP)11,600 psi (80 MPa)
Ballistic performance
Bullet mass/type Velocity Energy
350 gr (23 g) 1,200 ft/s (370 m/s) 1,125 ft⋅lbf (1,525 J)
Source(s): Barnes & Amber[1]

The .56-56 Spencer was an American black powder rifle cartridge.

.56-56 Spencer cartridge, bullet diameter .546 inches

Designed for the Spencer rifle and carbine, patented 6 March 1860, it was employed by cavalry during the American Civil War, first appearing at Sharpsburg in rifle form. No Spencer carbines were on issue at the Battle of Gettysburg, though two units under Custer had the rifles. The .56-56 was loaded with a slug of 350–360 gr (22.7–23.3 g) over 42–45 gr (2.7–2.9 g) of black powder. It was loaded by a variety of companies, and was also used in the Ballard and Joslyn carbines. It is a short-ranged cartridge, ineffective on anything larger than deer. Commercially loaded ammunition continued to be available into the 1920s and 1930s.

Nomenclature

The nomenclature of Spencer cartridges was unique. Unlike later cartridges such as the .44-40 Winchester and .45-70, where the first number indicated caliber and the second the charge weight, the .56-56 refers solely to the case. The first 56 is the diameter of the case at the base .56 inches (14.2 mm), measured just past the rim, and the second 56 is the diameter at the case mouth, also 0.56 inches (14 mm). Later versions of the cartridge included the .56-52, .56-50, and .56-46, which had varying degrees of taper in the cases, to accommodate smaller diameter bullets. All of these cartridges are rimfire primed. The actual bullet diameter of the .56-56 varied between .54 and .555 inches (13.7-14.1 mm), depending on ammunition manufacturer. The .56-52, made by Spencer, and the .56-50, made by Springfield, differed only in the degree of crimp, with the .56-50 having a greater crimp; both fired 350-grain (23 g) .512-inch (13.0 mm) bullets. The .56-46 fired a 320-grain (21 g) - 330-grain (21 g) .465-inch (11.8 mm) bullet.[1]

See also

References

  1. ^ a b Barnes, Frank C., ed. by John T. Amber. Cartridges of the World (Northfield, IL: DBI Books, 1972), p. 281, ".56-56 Spencer". ISBN 0-695-80326-3.