Jump to content

Talk:ANSI device numbers

Page contents not supported in other languages.
From Wikipedia, the free encyclopedia

This is an old revision of this page, as edited by SineBot (talk | contribs) at 18:51, 2 April 2020 (Signing comment by Gehrig64 - ""). The present address (URL) is a permanent link to this revision, which may differ significantly from the current revision.

86 relay

plese tell us if we can use new relay with out using lock out relay(86)

Wikipedia is a encyclopedia. Editors cannot provide Electrical engineering services. Please contact a registered Professional Engineer. 148.134.37.3 (talk) 13:28, 6 April 2011 (UTC)[reply]

certainly, 86 is only needed in case of you shall consider blocking subsequent closing after protection trip —Preceding unsigned comment added by 116.228.159.246 (talk) 09:34, 6 May 2011 (UTC) I agree that lockout relays are used when you want to prevent reclosing of a line after it trips. Most high voltage (69kV+) relaying schemes utilize lockout relays. It should be noted that for lines that are protected below 69kV in a round about way also utilize lockout relays. For lines below 69kV a breaker/recloser typically will try to reclose a set amount of times. If it is unsuccessful it will lockout and will have to be reset before the line can return to service. —Preceding unsigned comment added by Fleckmc (talkcontribs) 20:57, 8 May 2011 (UTC)[reply]

The indicated sources are no longer available. Different definitions can be found on the Internet. The information does not correspond to IEEE C37.2-2008 (e.g. 87N and others) — Preceding unsigned comment added by Gehrig64 (talkcontribs) 18:50, 2 April 2020 (UTC)[reply]