End of interrupt
 | This article needs additional citations for verification. (October 2021) |
An end of interrupt (EOI) is a signal sent to a programmable interrupt controller (PIC) to indicate the completion of interrupt processing for a given interrupt. An EOI is used to cause a PIC to clear the corresponding bit in the in-service register (ISR), and thus allow more interrupt requests (IRQs) of equal or lower priority to be generated by the PIC.[1][2]
EOIs may indicate the interrupt vector implicitly or explicitly. An explicit EOI vector is indicated with the EOI, whereas an implicit EOI vector will typically use a vector as indicated by the PICs priority schema, for example the highest vector in the ISR. Also, EOIs may be sent at the end of interrupt processing by an interrupt handler, or the operation of a PIC may be set to auto-EOI at the start of the interrupt handler.[3]
See also
- Intel 8259 – notable PIC from Intel
- Advanced Programmable Interrupt Controller (APIC)
- OpenPIC and IBM MPIC
- Inter-processor interrupt (IPI)
- Interrupt latency
- Non-maskable interrupt (NMI)
- IRQL (Windows)
References
- ^ Mika J. Järvenpää. "Linux Interrupts: The Basic Concepts" (PDF). University of Helsinki. Retrieved October 2, 2021.
- ^ "The 8259 Programmable Interrupt Controller (PIC)". osdev.org. Retrieved October 2, 2021.
- ^ "8259A Programmable interrupt controller" (PDF). Intel. December 1988. Retrieved October 2, 2021.
 | This computer hardware article is a stub. You can help Wikipedia by expanding it. |