Jump to content

Draft:Union Pacific 8080

From Wikipedia, the free encyclopedia

This is an old revision of this page, as edited by 110.175.62.4 (talk) at 04:26, 28 October 2023. The present address (URL) is a permanent link to this revision, which may differ significantly from the current revision.

Union Pacific 8080
Type and origin
Power typeGas Turbine-electric
BuilderUnion Pacific Railroad
ModelUnion Pacific GTEL
Build dateOctober 1962
Specifications
Configuration:
 • AARA1A-A1A+2-D+D-2
Gauge4 ft 8+12 in (1,435 mm)
Loco weight661 Mt (651,000,000 long tons; 729,000,000 short tons)
Fuel typeCoal (experimental)
Performance figures
Power output2,000 hp (1.5 MW) (ALCO PA-1)
5,000 hp (3.7 MW) (B-unit)
7,000 hp (5.2 MW) (Total)
Career
OperatorsUnion Pacific
ClassGTEL
Numbers80 (1962-1965)
8080 (1965-1968)
LocaleNorth America
First run1962
Last run1968
RetiredMarch 15, 1968
DispositionScrapped

Union Pacific 8080 is an experimental GTEL coal burner that was built by the Union Pacific Railroad themselves in October 1962.

History

In October 1962, the Union Pacific Railroad had constructed an experimental GTEL of their own, using a modified ALCO PA-1 as a cab, the chassis of a GN W-1-class electric locomotive which they bought for scrap from the Great Northern Railway as the second unit, and a modified turbine prime mover removed from one of the 50 to 75 series locomotives.

The consist had an A1A-A1A+2-D+D-2, wheel arrangement, 18 axles of which 12 were powered. The PA-1's 2,000 hp (1.5 MW) diesel engine was retained and the B unit carried the main power plant for the main generators, which contributed 5,000 hp (3.7 MW) for a total power output of 7,000 hp (5.2 MW). The coal tender was rebuilt from that of Challenger steam locomotive number 3990. The setup was numbered as #80, but was later renumbered to #8080 in 1965 to avoid conflict with the new EMD DD35s then being introduced.[1]

The blade erosion and soot build-up problems encountered in the earlier locomotives were magnified with the coal turbine. Grinding coal into fine particles was also troublesome but necessary because any oversized coal particles could damage the turbine blades. Ultimately, the experiment was declared a failure and was scrapped after spending only 20 months in service.

The conventional gas turbines each racked up well over 1,000,000 miles (1,600,000 km) in revenue service but the coal turbine prototype ran less than 10,000 miles (16,000 km) before being struck from the UP roster on March 15, 1968. The PA-1 control unit was traded to EMD, while the turbine unit and tender were scrapped at the Omaha shops.

References

  1. ^ UP's Coal Turbine Being Road Tested Railway Age December 17, 1962 page 37

See also