Productionisation

Productionisation is the process of turning a prototype of a design into a version that can be more easily mass produced. It is almost always a necessary step in the development of any product, since it is rare that the initial design is free from flaws or construction methods which make it difficult or more expensive to manufacture.

Prototypes are very often constructed by hand, or with more limited tooling. This is done to save costs where the design may not even be subsequently approved for manufacture. Once the go-ahead for a production run is given, the much more costly production tooling can be ordered. At this stage, the design iteslf may need to be reworked or altered to streamline production. The goal is to reduce costs as much as possible at the assembly stage, since costs will be multiplied by the number of units produced. For example, a prototype might be assembled using nuts and bolts, bu tin production such fasteners might be replaced by captive nuts or threaded holes built in to the parts, making assembly much faster, easier and therefore cheaper.

Sometimes limited runs of a design might be manufactured without full productionisation.

Other examples of productionisation might include:

• plastic mouldings instead of hand-constructed parts
• built-in fasteners
• snap-together or machine welded parts instead of using fasteners
• custom integrated circuits instead of discrete electronic components