Jump to content

Talk:Suzuki GT750

Page contents not supported in other languages.
From Wikipedia, the free encyclopedia

This is an old revision of this page, as edited by H2RICK (talk | contribs) at 03:40, 4 March 2009 (Comment on injection oiling system added. Cleaned up appearance of other comments.). The present address (URL) is a permanent link to this revision, which may differ significantly from the current revision.

WikiProject iconMotorcycling Unassessed
WikiProject iconThis article is within the scope of WikiProject Motorcycling, a collaborative effort to improve the coverage of Motorcycling on Wikipedia. If you would like to participate, please visit the project page, where you can join the discussion and see a list of open tasks.MotorcyclingWikipedia:WikiProject MotorcyclingTemplate:WikiProject MotorcyclingMotorcycling
???This article has not yet received a rating on Wikipedia's content assessment scale.
???This article has not yet received a rating on the project's importance scale.
To-do list:
Here are some tasks awaiting attention:

I'm not sure how to do this, but part of the info is misleading. A "total loss" oil system typically refers to older design 4 stroke motors where there is no valve cover. The top end of the motor has oil pumped to it(typically valves, valve springs, pushrods or cams) and then the oil just drips or blows off. The term does not apply to 2 stroke engines. Typically 2 stroke engines oil the crankshaft & connecting rod bearings and piston by either oil that is mixed with the gas or injected straight to the bearings. In either case, the oil does not accumulated, but gets sucked up and burned in the combustion chamber. Some 2 Strokes mix oil with gas in the gas tank, others inject the oil between the carb and the piston where it gets mixed with the gas/air mixture. The GT750 both injected oil directly to the bearings and piston and injected it between the carb and piston. Two strokes typically burn more oil than 4 strokes, but not always. The GT750 could do 500-800 miles on a quart. Thom Boswell thomboz@yahoo.com

The two stroke lubrication system is also "total loss", so the article is fine as far as I'm concerned. Sle (talk) 18:42, 7 September 2008 (UTC)[reply]

Actually, the injection style oiling system on two strokes can more properly be called a "once through" system.H2RICK (talk) 03:40, 4 March 2009 (UTC)[reply]

Retrieved from "https://en.wikipedia.org/enwiki/w/index.php?title=Talk:Suzuki_GT750&oldid=274844318"