MOX fuel
MOX fuel stands for Mixed oxide fuel. This type of nuclear fuel contains more than one oxide of fissionable material (more on fissile and fertile material). Specifically, MOX fuel refers to a blend of plutonium and natural uranium, reprocessed uranium, or depleted uranium. For example, a mixture of 7% Pu / 93% U (Plutonium/Uranium) reacts similarly - although not identically - to low-enriched uranium fuel that most nuclear reactors were designed for. MOX fuel is an alternative to low enriched uranium (LEU) fuel used in the light water reactors that predominate nuclear power generation.
One attraction of MOX fuel is that it is a way of disposing of surplus weapons-grade plutonium, which otherwise would have to be disposed as nuclear waste, and would remain a nuclear proliferation risk.[1] However, there have been fears that normalising the global commercial use of MOX fuel and the associated expansion of reprocessing will itself lead to greater proliferation risk.[2][3]
Overview
In every uranium-based nuclear reactor core there is both fission of isotopes such as uranium-235 (235
92U
), and the formation of new, heavier isotopes due to neutron capture, primarily by uranium-238 (238
92U
). Most of the fuel mass in a reactor is 238
92U
. This can become plutonium-239 (239
94Pu
) and by successive neutron capture plutonium-240 (240
94Pu
), plutonium-241 (241
94Pu
), plutonium-242 (242
94Pu
) and other transuranic or actinide isotopes. 239
94Pu
and 241
94Pu
are fissile, like 235
92U
. Small quantities of uranium-236 (236
92U
), neptunium-237 (237
93Np
) and plutonium-238 (238
94Pu
) are formed similarly from 235
92U
.
Normally, with the fuel being changed every three years or so, most of the 239
94Pu
is "burned" in the reactor. It behaves like 235
92U
, with a slightly higher cross section for fission, and its fission releases a similar amount of energy. Typically about one percent of the spent fuel discharged from a reactor is plutonium, and some two thirds of the plutonium is 239
94Pu
. Worldwide, almost 100 tonnes of plutonium in spent fuel arises each year. A single recycling of plutonium increases the energy derived from the original uranium by some 12%, and if the 235
92U
is also recycled by re-enrichment, this becomes about 20%.[4] With additional recycling the percentage of fissile (usually meaning odd-neutron number isotopes) in the mix decreases and even-neutron number, neutron-absorbing isotopes increase, requiring the total plutonium and/or enriched uranium percentage to be increased. Today in thermal reactors plutonium is only recycled once as MOX fuel, and spent MOX fuel, with a high proportion of minor actinides and even plutonium isotopes, is stored as waste.
Re-licensing precedes the introduction of MOX fuel into existing nuclear reactors. Often only a third to half of the fuel load is switched to MOX. The use of MOX does change the operating characteristics of a reactor, and the plant must be designed or adapted slightly to take it. More control rods are needed. For more than 50% MOX loading, significant changes are necessary and a reactor needs to be designed accordingly. The Palo Verde Nuclear Generating Station near Phoenix, Arizona was designed for 100% MOX core compatibility but so far have always operated on fresh low enriched uranium. In theory the three Palo Verde reactors could use the MOX arising from seven conventionally fueled reactors each year and would no longer require fresh Uranium fuel.
According to Atomic Energy of Canada Limited (AECL), CANDU reactors could use 100% MOX cores without physical modification. AECL reported to the United States National Academy of Sciences committee on plutonium disposition that it has extensive experience in testing the use of MOX fuel containing from 0.5 to 3% plutonium.
Current applications
Reprocessing of commercial nuclear fuel to make MOX is done in the United Kingdom and France, and to a lesser extent in Russia, India and Japan (including the damaged Reactor 3 at Fukushima I). China plans to develop fast breeder reactors and reprocessing. Reprocessing of spent commercial-reactor nuclear fuel is not permitted in the United States due to nonproliferation considerations. All of these nations have long had nuclear weapons from military-focused research reactor fuels except Japan.
The United States is building a MOX plant at the Savannah River Site in South Carolina. The Tennessee Valley Authority and Duke Energy are interested in using the reactor fuel from the conversion of weapons-grade plutonium.[5]
Thermal reactors
About 30 thermal reactors in Europe (Belgium, Switzerland, Germany and France) are using MOX[6] and a further 20 have been licensed to do so. Most reactors use it as about one third of their core, but some will accept up to 50% MOX assemblies. In France, EDF aims to have all its 900 MWe series of reactors running with at least one-third MOX. Japan aimed to have one third of its reactors using MOX by 2010, and has approved construction of a new reactor with a complete fuel loading of MOX. Of the total nuclear fuel used today, MOX provides 2%.[4]
Licensing and safety issues of using MOX fuel include:[6]
- As plutonium isotopes absorb more neutrons than uranium fuels, reactor control systems may need modification.
- MOX fuel tends to run hotter because of lower thermal conductivity, which may be an issue in some reactor designs.
- Fission gas release in MOX fuel assemblies may limit the maximum burn-up time of MOX fuel.
About 30% of the plutonium originally loaded into MOX fuel is consumed by use in a thermal reactor. If one third of the core fuel load is MOX and two-thirds uranium fuel, there is zero net gain of plutonium in the spent fuel.[6]
All plutonium isotopes are either fissile or fertile, although plutonium-242 needs to absorb 3 neutrons before becoming fissile curium-245; in thermal reactors isotopic degradation limits the plutonium recycle potential. About 1% of spent nuclear fuel from current LWRs is plutonium, with approximate isotopic composition 52% 239
94Pu
, 24% 240
94Pu
, 15% 241
94Pu
, 6% 242
94Pu
and 2% 238
94Pu
when the fuel is first removed from the reactor.[6]
Fast reactors
Because the fission to capture ratio of neutron cross-section with high energy or fast neutrons changes to favour fission for almost all of the actinides, including 238
92U
, fast reactors can use all of them for fuel. All actinides, including TRU or transuranium actinides can undergo neutron induced fission with unmoderated or fast neutrons. A fast reactor is more efficient for using plutonium and higher actinides as fuel. Depending on how the reactor is fueled it can either be used as a plutonium breeder or burner.
These fast reactors are better suited for the transmutation of other actinides than are thermal reactors. Because thermal reactors use slow or moderated neutrons, the actinides which are not fissionable with thermal neutrons tend to absorb the neutrons instead of fissioning. This leads to build up of heavier actinides and lowers the number of thermal neutrons available to continue the chain reaction.
Fabrication
The first step is separating the plutonium from the remaining uranium (about 96% of the spent fuel) and the fission products with other wastes (together about 3%). This is undertaken at a nuclear reprocessing plant.
Dry mixing
MOX fuel can be made by grinding together uranium oxide (UO2) and plutonium oxide (PuO2) before the mixed oxide is pressed into pellets, but this process has the disadvantage of forming lots of radioactive dust. MOX fuel, consisting of 7% plutonium mixed with depleted uranium, is equivalent to uranium oxide fuel enriched to about 4.5% 235
92U
, assuming that the plutonium has about 60–65% 239
94Pu
. If weapons-grade plutonium were used (>90% 239
94Pu
), only about 5% plutonium would be needed in the mix.
Coprecipitation
A mixture of uranyl nitrate and plutonium nitrate in nitric acid is converted by treatment with a base such as ammonia to form a mixture of ammonium diuranate and plutonium hydroxide. This after heating in 5% hydrogen in argon will form a mixture of uranium dioxide and plutonium dioxide. The resulting powder can be converted using a base into green pellets using a press. The green pellet can then be sintered into mixed uranium and plutonium oxide pellet. While this second type of fuel is more homogenous on the microscopic scale (scanning electron microscope) it is possible to see plutonium rich areas and plutonium poor areas. It can be helpful to think of the solid as being like a salami (more than one solid material present in the pellet).
Americium content
Plutonium from reprocessed fuel is usually fabricated into MOX as soon as possible to avoid problems with the decay of short-lived isotopes of plutonium. In particular, 241
94Pu
decays to americium-241 (241
95Am
) which is a gamma ray emitter, giving rise to a potential occupational health hazard if the separated plutonium over five years old is used in a normal MOX plant. While 241
95Am
is a gamma emitter most of the photons it emits are low in energy, so 1 mm of lead, or thick glass on a glovebox will give the operators a great deal of protection to their torsos. When working with large amounts of americium in a glovebox, the potential exists for a high dose of radiation to be delivered to the hands.
As a result old reactor-grade plutonium can be difficult to use in a MOX fuel plant, as the 241
94Pu
it contains decays with a short 14.1 year half-life into more radioactive 241
95Am
which makes the fuel difficult to handle in a production plant. Within about 5 years typical reactor-grade plutonium would contain too much 241
95Am
(about 3%). But it is possible to purify the plutonium bearing the americium by a chemical separation process. Even under the worst possible conditions the americium/plutonium mixture will never be as radioactive as a spent-fuel dissolution liquor, so it should be relatively straight forward to recover the plutonium by PUREX or another aqueous reprocessing method.
Also, 241
94Pu
is fissile while the isotopes of plutonium with even mass numbers are not (in general thermal neutrons will usually fission isotopes with an odd number of neutrons, but rarely those with an even number), so decay of 241
94Pu
to 241
95Am
leaves plutonium with a lower proportion of isotopes usable as fuel, and a higher proportion of isotopes that simply capture neutrons (though they may become fissile isotopes after one or more captures). The decay of 238
94Pu
to 234
92U
and subsequent removal of this uranium would have the opposite effect, but 238
94Pu
both has a longer halflife (87.7 years vs. 14.3) and is a smaller proportion of the spent nuclear fuel. 239
94Pu
, 240
94Pu
, and 242
94Pu
all have much longer halflives so that decay is negligible. (244
94Pu
has an even longer halflife, but is unlikely to be formed by successive neutron capture because 243
94Pu
quickly decays with a halflife of 5 hours giving 243
95Am
.)
Curium content
It is possible that both americium and curium could be added to a U/Pu MOX fuel before it is loaded into a fast reactor. This is one means of transmutation. Work with curium is much harder than work with americium because curium is a neutron emitter, the MOX production line would need to be shielded with both lead and water to protect the workers.
Also, the neutron irradiation of curium generates the higher actinides, such as californium, which increase the neutron dose associated with the used nuclear fuel; this has the potential to pollute the fuel cycle with strong neutron emitters. As a result, it is likely that curium will be excluded from most MOX fuels.
Thorium MOX
Fuel containing thorium and plutonium oxides has also been studied. This is sometimes but not always referred to as "Thorium MOX".
A Norwegian study finds that "the coolant void reactivity of the thorium-plutonium fuel is negative for plutonium contents up to 21%, whereas the transition lies at 16% for MOX fuel" and "Thorium-plutonium fuel seems to offer some advantages over MOX fuel with regards to control rod and boron worths, CVR and plutonium consumption."
See also
References
- ^ Military Warheads as a Source of Nuclear Fuel
- ^ Is U.S. Reprocessing Worth The Risk?
- ^ Plutonium proliferation and MOX fuel
- ^ a b "Information from the World Nuclear Association about MOX".
- ^ TVA might use MOX fuels from SRS, June 10, 2009
- ^ a b c d NDA Plutonium Options (PDF), Nuclear Decommissioning Authority, August 2008, retrieved 2008-09-07