Flight inspection
 |
The evaluation process, using properly equipped aircraft, regarding continuity, integrity and accuracy of significant parameters from radio navigation aids and procedures, aiming their calibration with international standards.
ICAO and FAA are most common international standards used within flight inspection.
VOR, ILS, NDB, VASI, DME, MLS, are different navigation aids and need periodic flight inspection.
Aircraft navigate. Traditional air navigation uses information given or sent by special dedicated transmitters on ground (called radio-navigation aids). There is a variety of aids’ type, supplying different information (bearing, distance, path deviation…) and, as any other electronic devices, these transmitters may fail, loose strength or accuracy, work out of tolerance or giving wrong information, with a prospective impact in airspace safety. This is the reason why a periodical flight service to check, verify and certify their data is needed. This is Flight Inspection for. Aircraft equipped with special and dedicated hardware (called Flight Inspection System) collect radio-navigation aids’ data and apply (compare with) international standards’ tolerance (this is called calibration), to validate electronic signal in space and certify final status of aids (so it to be published for general knowledge). The goal is having a safe air navigation infrastructure, ensuring the integrity of instrument approaches and airway procedures.
Arturo Cortijo 09:41, 17 June 2009 (UTC)
Flight Inspection Systems
Flight Inspection Systems are installed in aircraft containing antennas, receivers and sensors. Data received by this equipment is decoded by flight inspection computers and compared with the real position received by GPS. The result of this process is displayed on operator workstations also installed in the aircraft. One provider of such Flight Inspection System is Aerodata AG in Germany.