Jump to content

Castellated nut

From Wikipedia, the free encyclopedia

This is an old revision of this page, as edited by 115.250.111.157 (talk) at 19:49, 27 January 2014. The present address (URL) is a permanent link to this revision, which may differ significantly from the current revision.

Castellated nut
A car hub, with the central nut hidden behind a castellated nut cover that is locked against rotation using a cotter pin. The effect is similar to using a castellated nut.

A castellated nut, also called a castle nut or slotted nut, is a nut with slots (notches) cut into one end.[1] The name comes from the nut’s resemblance to the crenellated parapet of a medieval castle.

The bolt or axle has one or two holes drilled through its threaded end. The nut is torqued properly and then, if the slot is not aligned with the hole in the fastener, the nut is rotated forward to the nearest slot. The nut is then secured with a split pin or safety wire .It is a positive locking device.[1]

Castellated nuts are used in low-torque applications, such as holding a wheel bearing in place.[1]

References

  1. ^ a b c Barrett, Rich, Fastener Design Manual (PDF).