Blocked rotor test

Blocked rotor test is conducted on an induction motor. It is also known as short circuit test or locked rotor test or stalled torque test. From this test short circuit current at normal voltage, power factor on short circuit, total leakage reactance, starting torque of the motor can be found. The test is conducted at low voltage because if the applied voltage was normal voltage then the current flowing through the stator windings were high enough to over heat the winding and damage them. The blocked rotor torque test is not performed on a wound rotor motors because the starting torque can be varied as desired. However, blocked rotor current test is conducted on squirrel cage rotor motors.

Method

In the blocked rotor test, the rotor is locked. A low voltage is applied on the stator terminals so that full load current flows in the stator winding. The current, voltage and power input are measured at this point. When the rotor is stationary the slip, $s=1$. The test is conducted at $1/4^{th}$ the rated frequency as recommended by IEEE. This is because the rotor's effective resistance at low frequency may differ at high frequency. The test can be repeated for different values of voltage to ensure the values obtained are consistent. As the current flowing through the stator may exceed the rated current, the test should be conducted quickly. By using the parameters found by this test, the motor circle diagram can be constructed.

Calculations involved

Short circuit current at normal voltage

$I_{S}$ is the short circuit current at voltage $V_{S}$
$I_{SN}$ is the short circuit current at normal voltage $V$
$I_{SN}=I_{S}\times {\frac {V}{V_{S}}}$

Short circuit power factor

$W_{S}$ is the total input power on short circuit
$V_{SL}$ is the line voltage on short circuit
$I_{SL}$ is the line current on short circuit
$cos\phi _{S}$ is the short circuit power factor
$cos\phi _{S}={\frac {W_{S}}{{\sqrt {3}}{V_{SL}}{I_{SL}}}}$

Leakage reactance

$Z_{01}$ is the short circuit impedance as referred to stator
$X_{01}$ is the leakage reactance per phase as referred to stator
$Z_{01}={\frac {\text{short circuit voltage per phase}}{\text{short circuit current}}}={\frac {V_{S}}{I_{S}}}$

$W_{cu}$ is the total copper loss
$W_{c}$ is the core loss

$W_{cu}=W_{S}-W_{c}$
$W_{cu}={3}\times {{I_{S}}^{2}{R_{01}}}$

$R_{01}={\frac {W_{cu}}{3{I_{S}}^{2}}}$

$X_{01}={\sqrt {{Z_{01}}^{2}-{R_{01}^{2}}}}$

See also

• Open circuit test
• Circle diagram