Trailer brake controller
A brake controller is usually an OEM or aftermarket installed device or module. It is mounted to the tow vehicle's driver's-side dashboard area, and engages a trailer’s electrical braking system either time delayed, or in proportion to the tow vehicle's brake engagement when slowing down or coming to a halt. A brake controller is not needed with a trailer surge braking system unless using modern electric over hydraulic devices. The trailer in this case usually has either electric friction brakes or Electric-Hydraulic Trailer Brake Actuators.
Most basic brake controllers will generally have a +/- gain adjustment. The tow vehicle operator would set the gain as high as possible but without the trailer brakes locking up after making a few test stops. The heavier the trailer, the higher the gain adjustment would be set and therefore the less chances of wheel lock-up.[1]
A wide range of trailers will contain trailer brakes (for example; larger boat trailers, horse trailers, covered utility trailers, enclosed trailers, travel trailers including small 10-foot and longer tent trailers and car carriers). Smaller trailers may not contain trailer brakes (for example; basic 4'x8' utility trailers). It is highly recommended that, if the total trailer weight is over a couple thousand pounds, the trailer have some sort of braking system, and the tow vehicle be equipped with a brake controller.[2][3]
Controller Types
There are a different types of brake controllers that are currently or previously on the market.
Air Actuated Electric Brake Controller
This controller uses the air pressure of the brake system on a vehicle with pneumatic brakes to provide a current to control the electric brakes of a trailer.[4]
Hydraulic Over Electric Controller
This controller uses the hydraulic pressure of the brake system on a vehicle with hydraulic brakes to provide a current to control the electric brakes of a trailer.[5] Some truck manufacturers offers this as an OEM option, like Ford with its Ford TowCommand.
Pedal mounted pressure pad proportional controller
A separate sensor is mounted on the brake pad to connect to the controller.[6]
Proportional Brake Controller
Senses the deceleration of the vehicle through a pendulum or similar device to apply a suitable current for braking of the trailer.[7][8][9]
Surge Brake
When the tow vehicle slows down the trailer pushes against it an actuator applies force to its master cylinder and the hydraulic pressure is transferred to the brakes[10]
Time Delayed Brake Controller
Applies brake current with a ramp-up over time to a certain level set by the driver.[8][9][11]
References
- ^ "How to adjust a trailer brake controller".
- ^ What You Should Know About Trailer Brakes 1951 Popular Science article that covers the basics very well.
- ^ What You Should Know About Trailer Brakes, Popular Science, July 1969, pp. 111-113, an update of the 1951 article.
- ^ "Hayes Air Actuated brake controller".
- ^ "Maxbrake controller".
- ^ "AL-KO Sensabrake controller".
- ^ "Tekonsha proportional brake controllers".
- ^ a b "Curt brake controllers".
- ^ a b "Draw-Tite Proportional brake controllers". Cite error: The named reference "Draw-Tite Proportional" was defined multiple times with different content (see the help page).
- ^ "Hydraulic Surge Trailer Brake Actuators". Retrieved 2014-11-21.
- ^ "Hopkins brake controllers".