Specular reflection

Diagram of specular reflection

Reflections on water are an example of specular reflection.

Specular reflection is the perfect, mirror-like reflection of light (or sometimes other kinds of wave) from a surface, in which light from a single incoming direction is reflected into a single outgoing direction. Such behaviour is described by the law of reflection, which states that the direction of outgoing reflected light and the direction of incoming light make the same angle with respect to the surface normal; this is commonly stated as $\theta _{i}=\theta _{r}$.

This is in contrast to diffuse reflection, where incoming light is reflected in a broad range of directions. The most familiar example of the distinction between specular and diffuse reflection would be matte and glossy paints. While both exhibit a combination of specular and diffuse reflection, matte paints have a higher proportion of diffuse reflection and glossy paints have a greater proportion of specular reflection. Very highly polished surfaces, such as high quality mirrors, can exhibit almost perfect specular reflection.

Even when a surface exhibits only specular reflection with no diffuse reflection, not all of the light is necessarily reflected. Some of the light may be absorbed by the materials. Additionally, depending on the type of material behind the surface, some of the light may be transmitted through the surface. For most interfaces between materials, the fraction of the light that is reflected increases with increasing angle of incidence $\theta _{i}$. If the light is propagating in a material with a higher index of refraction than the material whose surface it strikes, then total internal reflection may occur.

Computer Graphics

File:Reflection60.jpg

3D model rendered with Ray Trace to demonstrate Specular Reflection.

Specular Reflection is added to surfaces in Ray Tracing to give them a shiny, realistic appearance.

The image on the right has reflection on the floor and back wall.

Holograms

Specular reflection is very important for making good scratch holograms, which are optically similar to Benton Rainbow Holograms (AKA: "White Light Holograms"); see also SPIE article and the FAQ, and the main Wikipedia Holography entry.