Cura (software)
| Developer(s) | David Braam, Ultimaker |
|---|---|
| Stable release | 2.3.1
/ 2016-11-08 |
| Repository | |
| Operating system | Windows, macOS, Linux |
| Available in | English |
| Type | 3D printer slicing application |
| License | Open source AGPLv3 |
| Website | ultimaker |
Cura is a 3D printer slicing application.[1] It was created by David Braam; he was later employed by Ultimaker to maintain the software. Cura has been released under the open source Affero General Public License version 3.[2] Development is hosted on GitHub.[2] Cura is the preferred slicer software for Ultimaker 3d printers, but can be used with other printers as well.[3]
Printer support
Cura supports the following printers:[3]
- All Ultimaker printers
- 3DMaker Starter
- BQ Hephestos 2
- BQ Prusa i3 Hephestos, XL
- BQ Witbox, 1 & 2
- Innovo INVENTOR
- Malyan M180
- Prusa i3, XL
- RepRap Neo
- RigidBot, RigidBotBig
Cura can also be customised to support printers other than those listed above.[3] UK-based 3d printer manufacturer CEL uses Cura as underlying slicing core for it’s Automaker printing application.
External links
GitHub development pages
- Cura Github development page
- Cura Github legacy (pre-Ultimaker) development page
- Cura slicing engine Github development page
References
- ^ "Cura home page". Ultimaker. Ultimaker. Retrieved 31 December 2016.
- ^ a b "Cura Github development page". GitHub. Retrieved 31 December 2016.
- ^ a b c "Which 3rd party printers are supported?". Ultimaker. Ultimaker. Retrieved 31 December 2016.