Jump to content

Talk:Organ printing

Page contents not supported in other languages.
From Wikipedia, the free encyclopedia

This is an old revision of this page, as edited by Lawallach (talk | contribs) at 17:36, 5 June 2018 (Update Science, Culture, and Society III assignment details). The present address (URL) is a permanent link to this revision, which may differ significantly from the current revision.

WikiProject iconMedicine C‑class Low‑importance
WikiProject iconThis article is within the scope of WikiProject Medicine, which recommends that medicine-related articles follow the Manual of Style for medicine-related articles and that biomedical information in any article use high-quality medical sources. Please visit the project page for details or ask questions at Wikipedia talk:WikiProject Medicine.MedicineWikipedia:WikiProject MedicineTemplate:WikiProject Medicinemedicine articles
CThis article has been rated as C-class on Wikipedia's content assessment scale.
LowThis article has been rated as Low-importance on the project's importance scale.

This article is or was the subject of a Wiki Education Foundation-supported course assignment. Further details are available on the course page. Student editor(s): Lawallach (article contribs).

I've got permission requests for copyrighted images hanging out in many a inbox. We'll have some posted, soon Ieopo 19:48, 14 November 2005 (UTC)[reply]

Confusion

"The gel is heat sensitive - solidifying at 32 degrees celsius and liquifying at 20 degrees." I'm just wonder if it's correct that it solidifies at a higher temperature than it liquifies. —Preceding unsigned comment added by Applejaxs (talk • contribs) 20:09, 30 September 2007 (UTC)[reply]

Peer Review Suggestions

I really like the information within this article, it covers a wide variety of areas and I know that I learned a lot by reading it.

Although a good bit of information, the third paragraph in the lead of this article is very specific and may fit better under the “3D Printing Techniques” or “Printing Materials” section, it is also lacking a citation.

The “Ethical Debate” section provides some very good points, yet argues points of view that are not neutral to wikipedia users.

The flow of the article is great for the most part, but may improve by putting the “Printing Materials” section before the “3D Printing Techniques” section.

Overall lots of good, balanced information within this article! Harejosi (talk) 00:06, 11 April 2017 (UTC)[reply]

Retrieved from "https://en.wikipedia.org/enwiki/w/index.php?title=Talk:Organ_printing&oldid=844557491"