Jump to content

Quarry

From Wikipedia, the free encyclopedia

This is an old revision of this page, as edited by Thewsomeguy (talk | contribs) at 03:00, 8 December 2019 (Reverted 1 edit by 2605:B100:71C:F1B1:9833:7672:3B7E:9AAD (talk) to last revision by Tikisim (TW)). The present address (URL) is a permanent link to this revision, which may differ significantly from the current revision.

Template:Distinguish-otheruses2

Carrara quarry in Tuscany, Italy
Portland stone quarry on the Isle of Portland, England
An abandoned construction aggregate quarry near Adelaide, South Australia
An abandoned stone quarry in Kerala, India
Stone quarry in Soignies, Hainaut (province), Belgium
Matera quarry in Basilicata, Italy

A quarry is a type of open-pit mine in which dimension stone, rock, construction aggregate, riprap, sand, gravel, or slate is excavated from the ground.

The word quarry can also include the underground quarrying for stone, such as Bath stone.

Types of rock

Types of rock extracted from quarries include:

Methods of Quarrying

Quarrying of stones: The method of removal of stones from their natural bed by using different operations is called quarrying. Methods of Quarrying – a) Digging – This method is used when the quarry consists of small & soft pieces of stones. b) Heating – This method is used when the natural rock bed is horizontal * small in thickness. c) Wedging –This method is used when the hard rock consists of natural fissure. When natural fissures are absent then artificial fissures are prepared by drilling holes. d) Blasting – It is the process of removal of stones with the help of controlled explosives is filled in the holes of the stones. Line of least resistance plays very important role in the blasting process. Following steps are used in the blasting process; 1) Drilling holes – Blast holes are drilled by using drilling machines. 2) Charging – Explosive powders are fed into the cleaned & dried blast holes. 3) Tamping – The remaining portion of the blast holes are filled by clay, ash, fuse & wirings. 4) Firing –The fuses of blasting holes are fired by using electrical power supply or match sticks.

Slabs

Many quarry stones such as marble, granite, limestone, and sandstone are cut into larger slabs and removed from the quarry. The surfaces are polished and finished with varying degrees of sheen or luster. Polished slabs are often cut into tiles or countertops and installed in many kinds of residential and commercial properties. Natural stone quarried from the earth is often considered a luxury and tends to be a highly durable surface, thus highly desirable.

Problems

Extraction work in a marble quarry in Carrara, Italy

Quarries in level areas with shallow groundwater or which are located close to surface water often have engineering problems with drainage. Generally the water is removed by pumping while the quarry is operational, but for high inflows more complex approaches may be required. For example, the Coquina quarry is excavated to more than 60 feet (18 m) below sea level. To reduce surface leakage, a moat lined with clay was constructed around the entire quarry. Ground water entering the pit is pumped up into the moat. As a quarry becomes deeper, water inflows generally increase and it also becomes more expensive to lift the water higher during removal; this can become the limiting factor in quarry depth. Some water-filled quarries are worked from beneath the water, by dredging.

Many people and municipalities consider quarries to be eyesores and require various abatement methods to address problems with noise, dust, and appearance. One of the more effective and famous examples of successful quarry restoration is Butchart Gardens in Victoria, BC, Canada.

A further problem is pollution of roads from trucks leaving the quarries. To control and restrain the pollution of public roads, wheel washing systems are becoming more common.

Quarry lakes

Many quarries naturally fill with water after abandonment and become lakes. Others are made into landfills.

Water-filled quarries can be very deep, often 50 ft (15 m) or more, and surprisingly cold, so swimming in quarry lakes is generally not recommended. Unexpectedly cold water can cause a swimmer's muscles to suddenly weaken; it can also cause shock and even hypothermia.[1] Though quarry water is often very clear, submerged quarry stones and abandoned equipment make diving into these quarries extremely dangerous. Several people drown in quarries each year.[2][3] However, many inactive quarries are converted into safe swimming sites.[citation needed]

Such lakes, even lakes within active quarries, can provide important habitat for animals.[4]

An abandoned limestone quarry in Rummu, Estonia.

See also

References

  1. ^ "American Canoe Association explanation of cold shock". Enter.net. Retrieved 2012-05-14.
  2. ^ "US Dept. of Labor list of mine related fatalities". Msha.gov. Retrieved 2012-05-14.
  3. ^ "on quarry drownings". Geology.com. 2007-11-03. Retrieved 2012-05-14.
  4. ^ Sievers, Michael (19 May 2017). "Sand quarry wetlands provide high-quality habitat for native amphibians". Web Ecology. 17 (1): 19–27. doi:10.5194/we-17-19-2017.{{cite journal}}: CS1 maint: unflagged free DOI (link)

S.K Duggal "Building Materials" (2003) 3rd revised edition