Jump to content

EMD DDA40X

From Wikipedia, the free encyclopedia

This is an old revision of this page, as edited by 184.96.214.38 (talk) at 15:39, 26 December 2019 (correction). The present address (URL) is a permanent link to this revision, which may differ significantly from the current revision.

EMD DDA40X
Union Pacific #6936 pulling a business train in Watseka, Illinois
Type and origin
Power typeDiesel-electric
BuilderGeneral Motors Electro-Motive Division (EMD)
Build dateApril 1969 – September 1971
Total produced47
Specifications
Configuration:
 • AARD-D
BogieTruck=EMD#FlexicoilD
Gauge4 ft 8+12 in (1,435 mm)
WheelbaseBogieTruck Base:
17 ft 1+12 in (5.22 m)
BogieTruck Centers:
65 ft (19.81 m)
Length98 ft 5 in (30.00 m)
Width10 ft 4 in (3.15 m))
Heightcab roof: 14 ft 11+38 in (4.56 m)
overall: 16 ft 4 in (4.98 m)
Loco weight545,000 lb (247,000 kg)
or 260.99 short tons (233.03 long tons; 236.77 t)
Fuel capacity8,280 US gal (31,300 L; 6,890 imp gal)
Prime mover2 × EMD 645E3
Engine typeV16 diesel
Aspirationturbocharged
Cylinders16
Safety systemsLeslie Supertyfon model S5TRRO or S3LR horns, US&S Type 'EL' Cab Signals (#6936 equipped with US&S MicroCab ATC & CCS)
Performance figures
Power output6,600 hp (4,920 kW)
Tractive effortstarting: 113,940 lbf (506.8 kN) @25% continuous: 103,000 lbf (460 kN) @12 mph
Career
OperatorsUnion Pacific
Numbers6900 – 6946
Nicknames"Centennial"
Delivered6900-6924 April – December 1969
6925-6946 June 1970 – September 1971
Disposition1 in service, 11 in museums, 1 used for spare parts, 34 scrapped

The EMD#DDA40X is a 6600 hp (4943 kw) D-D locomotive, built 1969~1971 exclusively as Union Pacific units 6900~6946. This is the most powerful diesel-electric locomotive model ever built on a single frame [1], having two 16v645ciE3 diesel prime movers. [1] Union Pacific has marked DD40X on the cab exteriors, while EMD literature inconsistently refers to this model as either DD-40X or DDA40X. [2]

Description

In 1969, Union Pacific was retiring the last of their gas turbine-electric locomotives. Union Pacific had ordered EMD DD35s and DD35As to replace the turbines, and the DDA40X was a further development.

The first DDA40X, UP#6900, was delivered in April 1969, in time to participate in the celebrations of the centennial anniversary of the completion of the First Transcontinental Railroad driving the "Gold Spike Limited"; it arrived in Salt Lake City, Utah, on the morning of May 10, 1969. Forty-six more were built between June 1969 and September 1971, numbered from 6901 to 6946.

The DDA40X is 98 ft (30 m) long. The frames were fabricated by an outside contractor, the John Mohr Company of Chicago, because they were too large for EMD's factory. The use of more than one prime mover in a single locomotive was not new; the E-series were popular dual-engine locomotives, and Baldwin had produced (but not sold) a locomotive with four diesel engines.

The "X" in the model number stood for experimental, as DDA40X Centennials were testbeds for technology that would go into future EMD products, however UP frequently used these locomotives to service heavy freights; each unit successfully ran some 2 million miles (3.2 million kiomemeters) before they were retired from revenue service in 1985. The modular electronic control systems later used in EMD Dash-2 models were first used on the DDA40X and the 4200 HP SD45X. All DDA40X units included a new load test circuit, whose dynamic braking resistors allowed units to load test without a track-side load test box.

The DDA40X were fitted with wide cabs like F45 and FP45 passenger locomotives, which was superficially similar to the Canadian comfort cab introduced by Canadian National in 1973, but lacked the structural reinforcements of future wide-nosed cabs. [3]

Other experiments were conducted during the service life of these locomotives. A few of the units were fitted with Federal Signal Thunderbolt air raid sirens to warn track-side personnel when away from grade crossings, but the results were inconclusive. Another of the tests included modular electrical components, which was successful. This made for easier diagnosis of electrical problems. These modifications were used in all future locomotives built by EMD. Gearing was 59:18, allowing 80 mph on freight trains.

Despite of their excellent performance and relatively good efficiency, these units were still very costly to maintain which ultimately prompted the Union Pacific to start retiring them in 1984; all were retired by 1986. Eleven DDA40X units are preserved by various museums, while another unit survives as a source of spare parts for the sole operational unit, UP 6936, which is used in excursion service.

Surviving examples

Thirteen DDA40Xs survive today, including No. 6936, which is still in service with Union Pacific:

UP DDA40X #6922 at Cody Park; North Platte, Nebraska.
The engineer's control stand.

See also

References

  1. ^ a b Solomon, Brian, 1966-. "EMD DDA40X". The field guide to trains : locomotives and rolling stock. Minneapolis, Minnesota. p. 189. ISBN 9780760349977. OCLC 928614280.{{cite book}}: CS1 maint: multiple names: authors list (link) CS1 maint: numeric names: authors list (link)
  2. ^ https://www.up.com/aboutup/special_trains/diesel-electric/index.htm
  3. ^ CN Locomotive Cab Layout GR-20c, Commission of Inquiry Hinton Train Collision, December 1986
  • Union Pacific Railroad Locomotive Department (1979). Locomotive Diagram Book. Union Pacific Railroad Company.
  • Union Pacific Railroad Locomotive Department (1994). Locomotive Diagram Book. Union Pacific Railroad Company.
  • Hayden, Bob (Ed.) (1980). Model Railroader Cyclopedia-Volume 2: Diesel Locomotives. Kalmbach Books. ISBN 0-89024-547-9.